- UID
- 339884
- 热情
- 10393
- 人气
- 14274
- 主题
- 10
- 帖子
- 289
- 精华
- 0
- 积分
- 12514
- 分享
- 0
- 记录
- 0
- 相册
- 0
- 好友
- 2
- 日志
- 0
- 在线时间
- 3066 小时
- 注册时间
- 2012-9-2
- 阅读权限
- 30
- 最后登录
- 2024-6-30
升级 50.28% - UID
- 339884
- 热情
- 10393
- 人气
- 14274
- 主题
- 10
- 帖子
- 289
- 精华
- 0
- 积分
- 12514
- 阅读权限
- 30
- 注册时间
- 2012-9-2
|
Through that a while back so not sure still the same.
I did 2 weeks, first week is stage 1 and 2. Stage 1 is basically electrical appliance test including type 1and 2.
Stage 2 is simple circuit like few lamp and a socket outlet.
You will need your usual hand tools and multi meters.
Stage 3 is ask to wire a "full" circuit including main switch board, a serials of light fitting, switch and socket. 3phase wiring output socket plus a electrical motor start circuit.
Best to have some test tools and hand/power tools. Not limited to drills, drill bits, testers.
Not too hard if you have some real experience, good luck |
|