有没有大佬在etco或etec考过电工的regulation和stage practical的

只开法拉利

如题 各位大佬介绍一下经验吧

sony313

在etec考的，挺简单的，只有有一点经验就不是很难

killingme

Through that a while back so not sure still the same.

I did 2 weeks, first week is stage 1 and 2. Stage 1 is basically electrical appliance test including type 1and 2.
Stage 2 is simple circuit like few lamp and a socket outlet.

You will need your usual hand tools and multi meters.

Stage 3 is ask to wire a "full" circuit including main switch board, a serials of light fitting, switch and socket. 3phase wiring output socket plus a electrical motor start circuit.

Best to have some test tools and hand/power tools. Not limited to drills, drill bits, testers.

Not too hard if you have some real experience, good luck