求大神看看这些灯表示啥意思？

redheart76

不可能啥事没有，用电脑一查，肯定会有faulty code

伤心小天

redheart76 发表于 2014-1-25 20:28
不可能啥事没有，用电脑一查，肯定会有faulty code

有人说是刹车片生锈，或刹车油不够，这个可能吗？

网络毛毛虫

The triangle with the exclamation mark inside, and the circular arrow around it, is the warning indicator symbol for the Electronic Stability Program (ESP). It should illuminate when you turn the key and extinguish after about 2 seconds after starting.


The ESP as well as the ABS system are intertwined. ESP uses the ABS to correct various safety/handling concerns by applying or releasing pressure to any particular wheel or wheels to help stabilize the vehicle. It can also, override throttle input if it is appropriate. An example would be if you had to swerve hard to avoid a collision at high speed. If the car were to begin to slide, be it understeer (front) or overseer (rear) the ESP would adjust throttle and wheel speeds to stabilize the vehicle. Quite amazing actually. Also, if you accelerate too quickly on ice it will adjust wheel speeds and the light will flash. This indicates the system is in "control mode".



As with ABS, it is supplemental and only comes into play when it is needed. If the MIL (Malfunction Indicator Light) is illuminated consider the system inoperative. The ESP controller must be scanned with a factory capable scanner for the Trouble Code Fault to determine the cause of the MIL illumination and testing of the effected component/circuit.



When you start the engine, if the light remains illuminated after starting, you can try to reactivate the system by shutting the vehicle off, and then restarting it. Also, there should be a ESP switch on your center console that turns the system off and on. Possibly you pressed this switch by mistake? The system can be shut off for special reasons explained in your owners manual under "Electronic Stability Program".


ESP = Electronic Stability Program malfunction indicator lamp (MIL)

1. You can try to disconnect the battery from car terminals, waiting for 30 minutes and connect again the cables in order to reset the ESP Electronic Control Unit (ECU).

2. If this procedure does not work you must use a diagnostic equipment connected to the Data Link Connector (DLC) of the car. The ESP ECU fault memory can only be accessed and erased using diagnostic equipment connected to the DLC.

Note: ESP function includes ABS (Antilock Braking System) function!

ESP  或者 ABS 有问题。。。

iphone100

伤心小天 发表于 2014-1-23 17:56
可是我刚去做的四轮定位检查，还有胎压，那个洋人师傅说我的胎压正常啊....

手刹。胎压不是那样的

爱国爱港

伤心小天 发表于 2014-1-23 18:20
好复杂......英文咋说呢？

DSC = Dynamic Stability Control

简单的英语说法可以说Traction Control