This article describes how to configure WDS (Wireless Bridging) in the 54g router
More Info
To upgrade your router to support WDS (Wireless Bridging), click here
To upgrade your access point to support WDS (Wireless Bridging), click here
Router Configuration
1. Open a Web Browser
2. In the address bar type http://192.168.2.1
3. Click on Wireless Bridge in the left hand column under Wireless
4. Enter your password if any and click Submit
5. Check the box that says Enable Wireless Bridging, click Apply Changes.
6. Click Home, note the WLAN MAC address under LAN settings
Access Point Configuration.
1. Open a Web Browser
2. In the address bar type http://192.168.2.254
3. Click on Wireless Bridge in the left hand column under Wireless
4. Enter your password if any and click Submit
5. Check the box that says, Enable Wireless Bridging
6. Check the box that says, Enable ONLY specific Access Points to connect and enter the WLAN MAC address from the router, click Apply Changes.
Note: The channel must be identical on both the router and the access point.
Note: The WDS feature is not completely specified in IEEE or Wifi standards. Therefore interoperability between 802.11 products of different vendors is not guaranteed.作者: 韩咲 时间: 2011-10-2 07:05:09